NMRWish Command List readROI Read a Region of Interest (ROI)

Command-Line Argument List

readROI: Read a Region of Interest (ROI).
Arguments for Reading a Region of Interest (ROI):
  -in     inName   [None]    Input Name (Required).
  -roi    roiID    [Current] ID Number for ROI.
  -ndim   finalDim [2]       Dimension Count for ROI.
  -key    keyData  [None]    Key Data Label/Data Pairs.
Arguments for In-Memory Reading:
  -inROI  roiID    [None]    Read from existing ROI.
  -inPtr  roiPtr   [None]    Read from existing data.
  -inHdr  hdrPtr   [None]    Read from existing header.
 ROI Limits By Upper and Lower Bounds;
  -x xName [x1 xn]  ROI X-Axis Source and Limits.
  -y yName [y1 yn]  ROI Y-Axis Source and Limits.
  -z zName [z1 zn]  ROI Z-Axis Source and Limits.
  -a aName [a1 an]  ROI A-Axis Source and Limits.
 ROI Limits By Center and +/- Width:
  -dx xName x0 [xW] ROI X-Axis Source, Center, Width.
  -dy yName y0 [yW] ROI Y-Axis Source, Center, Width.
  -dz zName z0 [zW] ROI Z-Axis Source, Center, Width.
  -da aName a0 [aW] ROI A-Axis Source, Center, Width.
 Alignment Options:
  -center axisList [None] Align Center of ROI.
  -left   axisList [None] Align Left Edge of ROI.
  -right  axisList [None] Align Right Edge of ROI.
  -edge   axisList [None] Align Both Edges of ROI.
Arguments for Report Generation:
  -noverb            Verbose Mode Off.
  -verb              Verbose Mode On.