NMRPipe Processing Functions POLY Polynomial Subtract

Command-Line Argument List

 
POLY: 1D Baseline Subtract.
Baseline Region Coordinates;
Valid Units: Pts Hz ppm %
 -sx1  x1     [1] Subtract Region.
 -sxn  xn  [SIZE] Subtract Region.
 -fx1  y1     [1] Initial Fit Region.
 -fxn  yn  [SIZE] Initial Fit Region.
 -x1   y1     [1] Sets -sx1 and -fx1.
 -xn   yn  [SIZE] Sets -sxn and -fxn.
 -nl   list  [No] Node List, Pts.
 -nw   wide   [1] Node Width +/- Pts.
Other Baseline Parameters:
 -ord  pOrd   [4] Baseline Order.
 -nc   cnt    [0] Initial Fit Nodes.
 -first      [No] Use First Points.
 -last       [No] Use Last Points.
 -avg        [No] Use Node Averages.
 -filt       [No] Use Sine Filter;
                  requires -avg flag.
Automated Baseline Correction:
 -auto      [No] Auto Baseline.
 -window     [8] Window Length, Pts.
 -frac    [0.33] Min Fraction of Data
                 which is Baseline.
 -nf       [1.5] Noise Factor.
 -noise    [0.0] RMS Noise Value.
                 Default is Auto.
Time Domain Correction:
 -time           Uses these Defaults:
                 -avg -nw 16 -fx1 NW+4 -nc SIZE/(2*NW+1)
                 Also Adjusts Sequential Data.
Fourier Series Correction:
 -sine       [No] Use Fourier Series.
 -p0        [0.0] Zero Order Phase.
 -p1        [0.0] First Order Phase.